MONARCH REMASTER
Welcome to the interactive assembly manual. Please verify your hardware contents before starting the structural calibration.
Swipe to start protocol ↓
UNBOXING
Gently slide the backrest out of the box and remove all remaining parts.
LOWER KINEMATICS
Place the wheelbase upside down and insert the 5 casters.
GAS LIFT CYLINDER
Insert the gas lift cylinder. Slide the gas lift cover over the cylinder.
BACKREST PREPARATION
Remove the 4 pre-installed M8 screws from the backrest.
RIGHT ANCHORAGE
Slide the right backrest bracket and tighten the screws halfway.
STRUCTURAL ALIGNMENT
Align the left reclining bracket and fully tighten all 4 screws on both sides.
MAGNETIC SHIELDING
Install the magnetic side covers onto the backrest brackets.
RECLINE TILT LOCK
Remove the red screw marked by the red safety tab from the right recline cover.
RECLINE ACTIVATION
Remove the red safety tab. This enables the reclining function.
POSITIONING
Lift the chair and place it facing downwards.
CONTROL LEVERS
Orient the tilt levers. Align the slots and insert them onto the shafts.
FROG MECHANISM
Orient the tilt mechanism. Bolt it to the underside of the seat base.
CHASSIS ASSEMBLY
Insert the hydraulic gas lift into the tilt mechanism or frog system socket.
FINAL DEPLOYMENT
Tilt the chair to an upright position while holding the wheel base.
SYSTEM ACTIVATED
Your Monarch Remaster is operational. Adjust the Omni-Cool™ technology, calibrate your recline, and dominate your environment.
